6-4
Okuma America Corporation
DIAGNOSTICSDIAGNOSTICS
DIAGNOSTICSDIAGNOSTICS
DIAGNOSTICS
Rev. 8-21-01
Lathe
Ia End point of arc
Ka End point of arc
C Target value of C axis
F Programmed F value (feedrate)
Fa Programmed dwell time (G04)
E Programmed E value (specifies the lead variation rate per pitch)
S Programmed S value (spindle speed)
T Tool number
Ta Tool offset number
Tx Tool offset value with respect to X axis
Tz Tool offset value with respect to Z axis
P Programmed P value (synchronization command for 4 axes cutting)
W Target value for W axis
SB Rotary tool command
WA (on LT 15-M)
N Sequence name
The following data is shown on the right side of the screen no matter which menu is selected in
the Block Data mode.
Sr Actual spindle speed
Sm Maximum spindle speed
fx Feedrate of X axis in mm/min
fz Feedrate of Z axis in mm/min
fm Axis traverse speed in mm/min
fr Axis traverse speed in mm/rev
Sb Rotary tool spindle speed
Om Main program name
Pr Programmed number of main program repetitions
Pe Actual number of programs executed
BC Block counter (number of lines executed)
Buffer Data
Full Buffer register is full
Empty Buffer register is empty
The three other menus in the Block Data mode are:
NEXT Displays the data to be executed after the “CURRENT” data.
QUEUED Displays the data to be executed after the “NEXT” data.
READ Displays the latest block of data stored in the buffer register.
To Next Page
