6-3
Okuma America Corporation
DIAGNOSTICSDIAGNOSTICS
DIAGNOSTICSDIAGNOSTICS
DIAGNOSTICS
Rev. 8-21-01
The following data is on a third page of the Actual Position mode.
Local Coordinates The distance referenced to the origin of the local coordinate system
Work Coords (APA) The distance referenced to the origin of the work
Work Coords coordinate system
Machine Coords The distance referenced to the machine origin (zero offset)
Feedback Coords Raw data coming from the absolute position encoder (RAPA)
Target Value The programmed destination point
Distance Remaining The distance remaining to the programmed destination point
Manual Shift Actual The manual shift amount of axis in the current operation
Manual Shift Total The total manual shift amount
Pitch Error Comp Shows the pitch error compensation at the present position
A-Mtd This indicates the normal running operation method has been selected for the
program being executed. B-Mtd would indicate a larger memory
volume was selected.
BLOCK DATA
The block data soft key allows the operator to access the menus that show the programmed
conditions of the machine one block at a time. The operator can see what block of information
is being, or will be executed. The following pertains to 5000/5020L controls.
Lathe
The “CURRENT” screen shows the program data of the currently executed block.
The left side of the screen shows the G and M codes that are in effect. The following is a de-
scription of the data shown in the Block Data mode.
X Target value of X axis
Z Target value of Z axis
Xa Target value of X axis in thread cutting mode
Za Target value of Z axis in thread cutting mode
Xb Starting point of thread cutting in X axis
Zb Starting point of thread cutting in Z axis
Xc Target point of thread cutting in X axis
Zc Target point of thread cutting in Z axis
I Programmed I value (radius of cut with respect to the X axis)
K Programmed K value (radius of cut with respect to the Z axis)
To Next Page
