7-4
Okuma America Corporation
LatheLathe
LatheLathe
Lathe
Rev. 8-21-01
CAUTION
Jog Feed
This parameters sets the amount of travel calculated when the axis is moved manually.
This parameter determines the axis travel speed in jog mode.
Accel Jog Feed
This parameter sets the amount of travel calculated when the axis accelerates and decel-
erates in jog mode.
Torque
This is the NC torque limiter parameter. The control will send out an alarm if the current
level in the drive amplifier exceeds the level set in this parameter. The number in this
parameter is the percentage of the total current capacity of the axis drive amplifier.
Turret Offset
This page of the system parameters shows the offsets of the individual tool stations.
These parameters allow the operator to move a tool from one station to another without
having to change the tool offset.
T
This page shows the system parameters for the NC turret (T axis). The following param-
eters are shown on this page.
Rapid Accel Rapid Torque PR Zero Offset
Jog Feed Accel Jog Feed Droop Data Unclamp Timer
If the acceleration unit amount (Accel Rapid) is changed to a value larger than the
preset one, it could adversely affect motor and machine performance. Therefore, be
sure to contact your Okuma distributor when a change of the acceleration unit amount
is desired.
To Next Page
