4-10
Okuma America Corporation
LatheLathe
LatheLathe
Lathe
Rev. 8-21-01
PARAMETER
By using the ITEM ↑ or ITEM ↓ key, various screens can be accessed after the PARAMETER
mode key has been pressed. The following bullets describe what the different screens show:
• User Parameters
• Chuck/Tailstock
• Common Variable
• System Parameters
• Optional Parameter (Long Word)
• Optional Parameter (Word)
• Optional Parameter (Bit)
• Turret Angle
• Turret Parameter Bit
Some of the screens displayed will have more than one page. These pages can be accessed by
pressing the key on the NC Operation Panel.
SET ADD CAL
BACK
UP
ITEM
↑
ITEM
↓
F1
F2
F3 F4 F5 F6 F7 F8
Used to set
new data
Used to
add to
currently
stored data
Calculates
data from
the actual
position
(RAPA)
Used to
immediate
ly back up
data. On
newer
OSP 5020
(1994 and
newer)
Used to access displays
related to parameter data.
P
To Next Page
Loading...
