4-27
Okuma America Corporation
MACHINE OPERAMACHINE OPERA
MACHINE OPERAMACHINE OPERA
MACHINE OPERA
TIONTION
TIONTION
TION
Rev. 8-21-01
A ON A and B turrets are activated individually according
B ON to the designated synchronizing commands.
Normal operation:
A OFF Normal machining cycle is performed according to
B OFF the programmed commands.
INTER This key is used to activate the following keys:
LOCK
DRY RUN
MACHINE LOCK
INDIVIDUAL MODE
The INTERLOCK key must be pressed at the same time as the aforemen-
tioned keys in order to activate those functions.
CRT This key is used to turn off the CRT display. It is used to
DISPLAY extend the life to the CRT.
SEQUENCE This key is used to restart the AUTO mode operation which has
RESTART been interrupted due to a tool breakage or a machining cycle was too long.
For details refer to the Operation Manual.
CONTROL Press this switch to turn on the power supply to the control and
ON/RESET the servo systems. The main switch on the side of the control cabinet has
to be turned on first. When the CONTROL ON switch is pressed, the
pilot lamp inside this push switch will turn on. This switch is also used to
reset the control.
CONTROL Press this switch to turn off power to the control and the servo
OFF systems. Always press this button first before turning off the main switch.
NC PANEL
EDIT LOCK The EDIT AUX and PARAMETER mode keys are
(OPT)(PL) disabled when the key is placed in this position.
UNLOCK All controls on the NC and Machine operation panels are
(ON)(|) enabled.
LOCK All controls on the NC operation panel are disabled.
(OFF)(O)
Stroke End Limit Cancel/Load Mode Panel
This small panel is found on the right inside wall of the control cabinet on the LNC-8 (Cadet)
and the LB 15. The following is a description of the switches on this panel.
Load Mode Turning this toggle switch on will put the control in the Load mode to load
new software.
Load Start Pushing this button will initiate the loading procedure.
System Reset Pushing this button resets the control. This is sometimes referred
to as a soft boot.
Stroke End With this toggle switch set to ON, the operator is allowed to use
Limit Cancel the Pulse Handle to move an axis off of a stroke end limit switch.
To Next Page
Loading...