Okuma OSP 5000 - OSP 5020 Construction Details; Diagnostics Procedures; Parameter Configuration; Software Management

TUESDAY SECTION
1. OSP 5020 Construction Five
A) Power Supplies
B) Printed Circuit Board Functions
C) Servo Systems
a) Axis Drives
b) Spindle Drives
D) Feedback Systems
2. Diagnostics Six
A) Using Actual Position Pages
B) Using Block Data Pages
C) Using Check Data Pages
WEDNESDAY
1. Diagnostics continued
D) Alarms
2. Parameters Seven
A) Setting Stroke End Limits
B) Setting Zero Offsets
THURSDAY
1. Software Eight
A) Data Management Card
B) Software Transfer Procedures
a) Backing up parameters
b) Initializing a B diskette
c) Loading software
2. Hands-On
FRIDAY
1. Hands-On
A) Troubleshooting