Olivetti PGL2645 - Energy Saver Function; Sleep and Auto Sleep

2-25
Installing and Setting up the Machine > Energy Saver function
Energy Saver function
If a certain period of time elapses after the machine is last used, the machine automatically enters sleep mode, which
minimizes power consumption.
Sleep and Auto Sleep
Auto Sleep
Auto Sleep automatically switches the machine into Sleep if left idle for a preset time.
The default preset time is 1 minute.
To resume, perform the following actions.
• Select the [OK] ke
y.
The machine will be ready to operate within 15 seconds for PG L2645, 20 seconds for PG L2650 and 25 seconds for
PG L2655.
Note that ambient environmental conditions, such as ventilation, may cause the machine to respond more slowly.
Follow the steps below to set the sleep timer for the machine
to g
o into sleep mode when not in use.
1
Display the screen.
[Menu] key > [▲] [] key > [Device Common] > [OK] key > [▲] [] key > [Timer Setting] >
[OK] key > [▲] [] key > [Sleep Timer] > [OK] key
2
Set the Sleep time.
1 Enter the Sleep time.
2 Select the [OK] key.
Status (Sleep Level Set.)
You can set whether sleep mode operates for each function. When the machine enters sleep mode, the ID card cannot
be recognized.
For more information on Status, refer to the following:
Status (page 8-31)
NOTE
If user login administration is enabled, you can only change the settings by logging in with administrator privileges.
If user login administration is disabled, the user auth
entication screen appears. Enter a login user name and
password, and select [Login].
The factory default login user name and login password
are set as shown below.
Login User Name: PG L2645: 4500 PG L2650: 5000
PG L2655: 5500
Login Password: PG L2645: 4500 PG L2650: 5000
PG L2655: 5500
NOTE
Use the numeric keys or select the [▲] or [▼] key to enter a number.