Olivetti PGL2645 - Power off Rule (Models for Europe)

2-26
Installing and Setting up the Machine > Energy Saver function
Sleep Level (Energy Saver and Quick Recovery) (models except for Europe)
For sleep level, you can toggle between the following two modes: Energy Saver mode and Quick Recovery mode. The
default setting is Energy Saver mode.
Energy Saver mode reduces power consu
mption even more than Quick Recovery mode, and allows Sleep Mode to be
set separately for each function. The ID card cannot be recognized.
Follow the steps below to select the sleep
level and use Energy Saver mode for each function.
1
Display the screen.
[Menu] key > [▲] [] key > [Device Common] > [OK] key > [▲] [] key > [Timer Setting] >
[OK] key > [▲] [] key > [Sleep Level Set.] > [OK] key
> [▲] [] key > [Sleep Level] > 
[OK] key
2
Select the Sleep level.
[▲] [] key > [Quick Recovery] or [Energy Saver] > [OK] key
When [Energy Save
r] is set, next go on to set whether or not to use Energy Saver mode for
each function.
3
Set the Sleep rule.
1 [▲] [] key > [Status] > [OK] key
2 Select the function to be set
, and select the [OK] key.
[Card Reader] is displayed when the optional Card Authentication Kit is activated.
3 [▲] [] key > [Off] or [On] > [OK] key
Repeat steps 3-2 to 3-3 to set for a different function.
Power Off Rule (models for Europe)
The Power Off Rule is used to stop the power from automatically turning off.
The default preset time is 3 days.
For more information on Power Off Rule settings,
refer to the following:
Power Off Rule (models for Europe) (page 8-31)
NOTE
If the optional Network Interface Kit is installed, this function will not be displayed.