Olympus 27MG - Page 97

DMTA-10043-01EN, Rev. C, July 2016
Index 89
NOTE 8
TIP 8
safety 7
CAUTION 7
DANGER 7
WARN ING 7
sound attenuation 63
sound scattering 62
sound velocity 77
default 31
sound waves 59
specifications, general 57
standard resolution, measurement 31
standards, EN15317 58
storage instructions, batteries 24
strap ring, instrument 17
strap rings, protective rubber boot 16
support information, technical 13
surface condition 61
symbols 1
safety, description 6
CE 2
Korean standard 3
RCM (Australia) 2
RoHS 10
WEEE 2
System Setup tabs 50
T
T/R transducer connectors 18
taper, contact surface 62
technical support 13
temperature
high ~ measurement, transducers 65
range, instrument operating 57
thickness range 57
thickness value, radix 51
TIP signal word 8
title bar, parameter screen 29
transducer zero compensation, calibration 36
transducers
connectors, Transmit/Receive 17
diagnosing defective ~ 70
dual element ~, measurement mode 57
frequency range 57
high temperature measurements 65
maintenance 69
positioning/alignment 61
selection 63
zero compensation 35
Transmit/Receive connectors 4, 17
turning on or off, instrument 17
U
ultrasonic velocities, table 77
units, LCD display 58
changing 47
unknown material sound velocity 38
up arrow key 19
USB connector 17
location 18
protecting door 17
use, intended 5
V
VEL secondary key 20
velocity and zero calibration 36
velocity range, material 57
velocity variations 63
velocity, sound, default 31
video test 74
W
WARNING signal word 7
warnings, general 8
warranty information 12
waste electrical and electronic equipment 10
waterproofness, partial 69
WEEE directive
marking 2
symbol 10
weight, instrument 57
wrist strap 16
writing convention, parameter selection 29
Z
zero calibration or CAL ZERO 35, 39
zero compensation, transducer calibration 36