Olympus EVIS EXERA II - Chapter 4: Operation

52
Chapter 3 Preparation and Inspection
ULTRASOUND GASTROVIDEOSCOPE GF-UCT180
2. Inspect the endoscopic ultrasound center as described in its instruction
manual.
3. When setting the frequency, choose the setting value CLA2, and then the
frequencies available with the keyboard (see Figure 3.22). Refer to
EU-ME1’s instruction manual for instructions on how to set the frequency.
Figure 3.22
4. Press the “FREEZE” switch on the diagnostic ultrasound system to change
the ultrasound image to the REAL-TIME mode.
5. Confirm that the ultrasound image is visible on the endoscopic ultrasound
center (see Figure 3.23).
Figure 3.23
6. Press the “FREEZE” switch to change the ultrasound image to the FREEZE
mode.
Ultrasound image (B-mode)