OMEM710 Hardware Manual 2v11
8
Calibrate warm engine starting fuel.
Cold starting / running setup
It is important to calibrate the cold running in the correct order as some of the tables are in effect all
of the time and so will affect the results of others.
Start engine from cold however you can (ignoring the cold cranking fuel for now), and calibrate the
Coolant Fuel trim table and the Accel Coolant trim table. The Coolant fuel trim table is used for
steady-state engine running, and the Accel Coolant trim table for increased acceleration fuel whilst
cold. Refer to the relevant sections for further advice on this.
When the cold running is complete, you can calibrate cold starting. Refer to the relevant section for
advice on this.
To Next Page
Loading...
