MF 64
Author: Donato Gavino Murru donato.gavino.murru@omgitaly.com Pag. 110 a 179
Chains moves when all stations are in open position and machine is ready only.
Make sure when using film index inversion button, not to accumulate
film in index system. You will need to pull on plastic film while using
inversion mode. Not doing so may result in damage to the product.
Beware when starting automatic cycle that the film is well perforated by
the pin chain and that it is inserted by a minimum of 30 cm inside the
index system. It will avoid material to deviate on chain and fall inside
lower heating panel. Not doing so may result in damage to the product.
Film index advance jog mode button.
Used when entering film in machine.
Reversing film index rotation button. If
non-woven is misplace on the pin
chain, reverse index to reinstalling it.
Rails width selector for the entry film regulation
To Next Page
Loading...