OMG MF 64 - Adjustments & Setup

MF 64
Author: Donato Gavino Murru donato.gavino.murru@omgitaly.com Pag. 171 a 179
Adjustments & Setup
Regulate the weights on the two side, front and rear, in relation to the hardness and thickness of
the material , and check if these work well by switch “on” the electrical selector
Table for device control
By moving the weight from
both side, it’s possible to
adjust the balancing pull of
the scrap
Device check switch
Gearmotor for scrap
wrapping
Inclusion / exclusion
function selector