OMG MF 64 - Page 57

To Next Page

To Previous Page

MF 64

Author: Donato Gavino Murru donato.gavino.murru@omgitaly.com Pag. 56 a 179

Final look after remove the #2 pillars

used for delivery (front and rear) and

all security system (Photo taken from

the rear sides of the machine)

Main Page

Table of Contents4
Starting8
General Warning9
Installation and Wiring Precautions11
Operation and Adjustment Precautions13
Label14
Overview16
Generalities about the Machine - Description - Performances16
Allowed Working Materials17
Right and Wrong Use18
General Advising18
Features19
Noise19
List of Functional Groups20
Interchangeable Tools20
Dimension of the Machine21
Safety22
General Considerations for the Purposes of the CE Directive22
Front Side23
Left Side24
Right Side25
Rear Side26
Machine Limits32
Safety Requirements: Applicability34
Security Requirements: General Considerations34
Evaluation Form for Essential Safety Requirements36
Transport, Install & Maintenance39
General Description39
Lifting Points58
Foundations and Positioning on Floor61
Machine Levelling62
Electrical Connections65
Connect the Cables, on the Appropriate Terminal, Following These Instructions66
Water Connections70
Water Scheme71
Cooling System71
Main Manifold72
Cooling Sections of the Machine73
Pneumatic Connection75
Unpacking, Positioning and Assembly76
Main Spare Parts77
Safety77
Touch Screen78
General Description78
Schematic79
Main Spare Parts80
Troubleshooting80
Safety80
Remote Assistance81
Machine Management82
Starting and Main Pages82
Unwind Reel84
General Description84
Schematic84
Adjustments & Setup85
Automatic Cycle90
Main Spare Parts92
Troubleshooting93
Safety94
Edges Pre-Heater95
General Description95
Schematic96
Adjustments & Setup97
Main Spare Parts101
Troubleshooting102
Safety103
Index Device104
General Description104
Schematic104
Adjustments & Setup105
Rails Chain Cooling System109
Automatic Cycle110
Main Spare Parts112
Troubleshooting113
Safety114
Heating Device115
General Description115
Schematic115
Adjustments & Setup116
Heater Carriage Speed Adjustment in and out of the Machine118
Adjustment of the Sagging Sensor for Non-Woven Film Indexing119
Set up for the Power Intensity of Ceramic Heating Elements120
Temperature121
Automatic Cycle122
Troubleshooting125
Safety127
Forming Device128
General Description128
Schematic128
Swivel out the Forming Station129
Tables Adjustments134
Automatic Cycle142
Main Spare Parts144
Troubleshooting145
Safety146
Trim Press Device147
General Description147
Schematic147
Adjustments & Setup148
Automatic Cycle153
Main Spare Parts156
Troubleshooting157
Safety157
Stacker Device158
General Description158
Schematic159
Common Adjustments160
Stacker Mode: Type G164
Automatic Cycle167
Main Spare Parts169
Troubleshooting170
Safety170
Scrap Wrap Device171
General Description171
Schematic171
Adjustments & Setup172
Automatic Cycle173
Main Spare Parts174
Troubleshooting174
Safety175
File Save & Open176
General Description176
Saving Function177
Work Data Updating180

OMG MF 64 - Page 57

Table of Contents