MF 64
Author: Donato Gavino Murru donato.gavino.murru@omgitaly.com Pag. 86 a 179
Pull manually the end material to unwind, a sufficient quantity to install I inside the calendar. Lift the
two handles located on both side of the unwinder.
Use unroller switch to unroll the material. The unroller will stop when material darken the photocell
located at the base of the system. When the photocell will get free again, the unroller will function if
selector is engaged.
Note: Let the unroller turns until the photocell will darken. That way, it will be possible to obtain a
feeding reserve of material, mandatory when the machine is cycling.
Lift the roll from ground to avoid the
material to get scratch from the floor.
Lift the upper part of the calendar with the
levers and introduce the material.
Use this command to activate the calendar.
To Next Page
Loading...