“Collect all data” – data collection and transmission same as with ignition turned
on.
“Collect all except GPS” – collection and transmission of data selected during
configuration of the terminal, except for the GPS module data
“Collect data at jolting” – monitoring the status of the panic button and
accelerometer. If the accelerometer reading changes by more than 0.2 g or the
panic button is pressed, the terminal switches to the “Collect all data” and performs
data transmission to the Communication Server in 5 minutes
When selecting “Collect data at jolting” set the following configuration:
“Collect all data” – when this parameter is enabled, the terminal upon expiration of
the time specified in the “Period of data sending to Server” switches to the “Collect
all data” mode and performs data collection and transmission to the
communication server. After the data transmission the terminal switches to the
“Collect data during pounding” mode.
“Interval of sending data to the server (h)” – the time interval between the terminal
connections to CS.
Depending on the set mode, the data are acquired from the particular modules and
external devices.
“Adaptive data collection at cornering” – enable/disable adaptive data collection on
turns, which allows increasing the accuracy of displaying turns on the map by
additional data collection from the GPS module more frequently than set in the “Data
collection” parameter.
“Collecting data on the traveled distance” – allows increasing the accuracy of
displaying the vehicle location on the map by additional data acquisition from the
GPS module over the distance traveled between the events with registered
coordinates.
“Distance traveled” – enter the mileage traveled from the moment of the last
registered event with coordinates, upon achieving which the data will be acquired.
Possible values: from 10 to 1000 meters. Default value – 100 meters.
“Coordinate drift filtering” – enable to eliminate runout of coordinates during the
“Track” report generation.
When enabling the “Coordinate drift filtering” the following settings are available:
“Delay after ignition on, sec”. Default value – 35 sec. Possible values: from 0 to 900.
To Next Page
Loading...
