SMS command *UNBLOCK# to the SIM card, inserted in the terminal.
Remote Configuration Server Operation Setting
Set password on terminal settings modification by either of the following ways:
When configuring the terminal using Omnicomm Configurator set password on
settings modification that is different from the password set by default. Password
set by default – empty line
Send SMS command to change password set by default: *SETPWDID 235009988
12345#
where: 235009988 – terminal ID; 12345 – password to be set. The password shall
contain 8 characters maximum and may include any digits and letters.
The previously set password cannot be changed in this way.
After 6 hours, the terminal will be authorized on the Remote Configuration Server and
will be available for operation via the Remote Configuration Server.
Terminal SIM Card Number Identification
The terminal SIM card telephone number is automatically displayed in the Remote
Configuration Server after the second connection to the RCS.
SMS sending shall be enabled for the SIM card.
Additional Equipment
RS-485 and RS-232 Interfaces
Connection of auxiliary equipment (CAN-Log, PP-01 passenger throughput sensors,
DV-1 driver display, JPEG camera, data reception from vehicle J1708 data bus,
reception and transmission of navigation data as per NMEA standard) is carried out
through RS-485 and RS-232 interfaces. When needed, it is recommended to use the RS-
232 to RS-485 converter.
In the “Settings” window open the “Inputs” tab:
To Next Page
Loading...
