Select the criterion for the terminal connection to the CS: “Interval of sending data to
CS” or “Data package size to be sent to CS”.
“Interval of sending data to the CS” – enter the number of minutes, upon expiration
of which the terminal must establish connection with the communication server,
while being in roaming. Recommended value – 180 minutes.
“Data packet size to send to CS” – enter the data batch size, upon achieving which the
terminal must establish connection with the communication server, while being in
roaming. Recommended value – 100 Kb.
In the “Roaming settings” section:
“Roaming” – select the option of SIM card using while in roaming. Possible options:
• “Allow” - the terminal will transmit data using the available cellular networks
• “Deny” - the terminal will not transmit data while roaming
• “In roaming as at home” - the terminal will transmit data following the same settings
of output parameters as for the home network
• “According to the list” - the terminal will only transmit data using the cellular
networks stated in the list. Enter the MCC and MNC of the required cellular networks
in the table
When the terminal operates in roaming, the data transmission is carried out only to
the communication server no. 1. To transfer data to two communication servers, select
"In roaming as at home".
Selection of Ignition Source
In the “Settings” tab select the “Inputs” section from the list.
In the “Ignition key status” section:
To Next Page
Loading...
