Equipment Omnicomm 3.0 Terminals 65 microphone to the Omnicomm Optim
terminal is shown on the diagram:
RFID Reader Connection
The terminal supports connection of swipe card readout devices via 1-Wire physical
interface.
The connected readout device must fully simulate the exchange protocol of DS1990A
product.
Timing diagrams must be executed for all officially declared specifications.
Controlled Equipment
In the terminals, for each controlled output, up to three rules are provided for
operation.
The rules are set by event or by a combination of events and states.
In the “Settings” tab select the “Outputs” section from the list.
“Rule priority” – set the priority of the rule. When at the same time several rules apply,
a rule with the highest priority is used.
Possible options: 1 (highest), 2, 3 (lowest).
To Next Page
Loading...
