To select the CAN bus as a data source enable SPN 582 and SPN 928 in the CAN
settings tab.
If the ALM Weight Indicator and the CAN Bus are both set as data source, the ALM
Weight Indicator will be used.
“Number of axles” – set the number of vehicle axles. Possible values: from 1 to 8.
Maximum value – 8 for CAN, 6 for ALM.
“Axle load threshold, tonnes” – enter the value of load on each axle, upon exceeding
which an event will be registered.
“Sound notification” – enable/disable sound notification if thresholds of monitored
parameters are exceeded
“Events” – enable/disable event sending to Omnicomm Online
“Photo” – enable digital camera photo sending upon load exceeding
“SMS” – enable SMS sending upon load exceeding
“Total load threshold, tonnes” – enter the value of total vehicle load, upon exceeding
which an event will be registered.
“Sound notification” – enable/disable sound notification if thresholds of monitored
parameters are exceeded
“Events” – enable/disable event sending to Omnicomm Online
“Photo” – enable digital camera photo sending upon load exceeding
“SMS” – enable SMS sending upon load exceeding
Body Tampering Control
In the “Settings” tab select the “Additional equipment” section from the list.
In the “Case tampering detection” section:
“Send an SMS upon an attempt open the case” – enable/disable SMS sending upon
triggering the anti-tamper switch.
Internal Battery
To Next Page
Loading...
