Omron 3G3MX2 - Page 300

5-183
5-14 Other Functions
SYSDRIVE MX2 Series USER'S MANUAL (3G3MX2-A@@@@)
5
Functions
The following parameters are not displayed in High-frequency Mode.
Parameter No. Function name
d009 Torque Reference Monitor
d010 Torque Bias Monitor
d012 Output Torque Monitor
A097 Acceleration Pattern Selection
A098 Deceleration Pattern Selection
A131 Acceleration Curve Parameter (S, U, reverse U)
A132 Deceleration Curve Parameter (S, U, reverse U)
A150 EL-S Shape Acceleration Curve Ratio 1
A151 EL-S Shape Acceleration Curve Ratio 2
A152 EL-S Shape Deceleration Curve Ratio 1
A153 EL-S Shape Deceleration Curve Ratio 2
b040 Torque Limit Selection
b041
Torque Limit 1 (Four-quadrant Mode Forward Power
Running)
b042
Torque Limit 2 (Four-quadrant Mode Reverse
Regeneration)
b043
Torque Limit 3 (Four-quadrant Mode Reverse Power
Running)
b044
Torque Limit 4 (Four-quadrant Mode Forward
Regeneration)
b045 Torque LADSTOP Selection
b046 Reverse Rotation Prevention Selection
b049 Heavy Load/Light Load Selection
b089 Automatic Carrier Reduction
C054 Overtorque/Undertorque Selection
C055 Overtorque/Undertorque Level (Forward Power Running)
C056 Overtorque/Undertorque Level (Reverse Regeneration)
C057 Overtorque/Undertorque Level (Reverse Power Running)
C058 Overtorque/Undertorque Level (Forward Regeneration)
C059 Overtorque/Undertorque Signal Output Mode Selection
H001 Auto-tuning Selection
H002 Motor Parameter 1
H202 Motor Parameter 2
H005 Speed Response 1
H205 Speed Response 2
H020 Motor 1 Parameter R1
H220 Motor 2 Parameter R1
H021 Motor 1 Parameter R2
H221 Motor 2 Parameter R2
H022 Motor 1 Parameter L