A
A-4 CP1L Programming Examples
120 SYSMAC CP1L Getting Started Guide
Appendix
4. On the IN0 drop-down list for Interrupt Input, select [Quick].
While the sensor input contact is 0.04, setup is performed for [IN0] since
the interrupt input / quick-response input setting is set to 0.
5. Close the PLC Settings dialog box.
6. To apply changes made to the PLC settings, turn the PLC power ON.
Programming Example
zLadder Program
CNT
0000
#0100
100.00
Count complete
C0000
Sensor input
0.04
0.01
Counter reset input
BCD counter
W07E-EN-02+CP1L+GettingStartedGuide.book Seite 120 Montag, 15. September 2008 11:15 11
To Next Page
Loading...
