116
Remote Adapters Section 4-6
Input Devices
Use a printed circuit board to wire I/O devices to a flat cable MIL plug which
can be connected to the Remote Adapter.
Note In accordance with the changes in the standards for photoelectric sensors
and proximity sensors, wire colors have been changed. Colors in parentheses
are the old wire colors.
Dimensions The following diagram shows the dimensions for the DRT1-ID16X and DRT1-
ID16X-1 Remote Input Adapters. All dimensions are in mm.
Brown
(red)
Black
(white)
Blue
(black)
Brown
(white)
Blue
(black)
–
+
NPN output 3-wire sensor
(photoelectric or proximity sensor)
2-wire sensor
(limit switch)
I/O power supply
Connector pin No.
▲ Triangle mark
Top View
Two, 4.2 dia. or M4
85 max.
40 max.
Approx. 73
Mounting holes
Flat cable length: Approx. 60
40 0.3
±
75 0.3
±
(With connector attached)
50 max.12
To Next Page
Loading...
