Omron DRT1 Series - Mounting in Control Panels

59
Transistor Remote I/O Terminals Section 4-3
2. Line colors have been changed accompanying changes in JIS standards
for photoelectric and proximity sensors. Previous colors are given in paren-
theses.
Dimensions The following diagram shows the dimensions for the DRT1-MD16 Remote I/O
Terminals. All dimensions are in mm.
4-3-7 Mounting in Control Panels
Either of the following methods can be used to mount an Remote I/O Terminal
in a control panel.
Using Screws Open mounting holes in the control panel according to the dimensions pro-
vided for mounting holes in the dimensions diagrams and then secure the
Remote I/O Terminal with M4 screws. The appropriate tightening torque is 0.6
to 0.98 N
⋅m.
Using DIN Track Mount the back of the Remote I/O Terminal to a 35-mm DIN Track. To mount
the Terminal, pull down on the mounting hook on the back of the Terminal with
a screwdriver, insert the DIN Track on the back of the Terminal, and then
secure the Terminal to the DIN Track. When finished, secure all Slaves on
both ends of the DIN Track with End Plates.
REMOTE TERMINAL 24VDC
0 1234567
IN
OUT
753
642
No.
NSMS
1
0
753
642
1
0
1 2345670
140±0.3
Two, 4.2 dia. or M4
Mounting holes
150 max.
40±0.3
50 max.
40 max.
Approx.73
DRT1-MD16
12
(With connector attached)