256
C200H I/O Link Units Section 6-1
6-1-10 Dimensions
For dimensions of the Unit when mounted to a Backplane, refer to the SYS-
MAC C200HX/HG/HE PLC Operation Manual or the SYSMAC CS1G/H PLC
Operation Manual.
6-1-11 Installing in a Control Panel
The C200H I/O Link Unit must be mounted in the Backplane of a CS1H/G or
C200HX/HG/HE PLC. The Unit mounts in the Backplane just like standard
Units. Refer to the PLC’s Operation Manual or Installation Guide for details on
mounting the Unit in the Backplane and installing the PLC in a control panel.
Note The C200H I/O Link Unit uses work words in the PLC (CS1H/G or C200HX/
HG/HE) to exchange I/O data with the Master, so it isn’t necessary to wire an
internal power supply, I/O power supply, or I/O lines.
6-1-12 C200H I/O Link Unit Application Examples
This section explains the procedure for using explicit messages with a C200H
I/O Link Unit. The following system configuration example is used in this
example. When explicit messages are used with a C200H I/O Link Unit, the
areas in the Slave’s PLC can be read or written.
13
101
35
130
Unit: mm
(With connector attached)
DRT21
To Next Page
Loading...
