132
Sensor Terminals Section 4-7
Dimensions
The following diagram shows the dimensions for the DRT1-ND16S Sensor
Terminal. All dimensions are in mm.
4-7-4 Mounting in Control Panels
Either of the following methods can be used to mount an Sensor Terminal in a
control panel.
Using Screws Open mounting holes in the control panel according to the dimensions pro-
vided for mounting holes in the dimensions diagrams and then secure the
Sensor Terminal with M4 screws. The appropriate tightening torque is 0.6 to
0.98 N
⋅m.
Using DIN Track Mount the back of the Remote Adapter to a 35-mm DIN Track. To mount the
Adapter, pull down on the mounting hook on the back of the Terminal with a
screwdriver, insert the DIN Track on the back of the Terminal, and then secure
the Terminal to the DIN Track. When finished, secure all Slaves on both ends
of the DIN Track with End Plates.
150 max.
40 max.
Approx. 73
Two, 4.2 dia. or M4
12
Mounting holes
40± 0.3
140 0.3
±
(With connector attached)
50 max.
To Next Page
Loading...
