126
Sensor Terminals Section 4-7
Components
I/O connectors
Connect the special connectors from the sensors here.
(The special connectors are attached to the sensor's cable.)
I/O indicators
Indicate the status of each contact. (Lit when the input or output is ON.)
DIN track mounting hooks
ev
ce
et
n
cators
Power supply terminals
Communications connector
DIP switch
Pins 1 to 6: Node address setting
Pins 7 and 8: Baud rate setting
Pin 9 and 10: Reserved (Always OFF.)
Word address
Indicates the word which the
sensor uses.
(Refer to page 312.)
(Refer to page 40.)
To Next Page
Loading...
