130
Sensor Terminals Section 4-7
Components
Internal Circuits The following diagram shows the internal circuits for the DRT1-ND16S Sensor
Terminal.
I/O connectors
Connect the special connectors from the sensors here.
(The special connectors are attached to the sensor's cable.)
I/O indicators
Indicate the status of each contact. (Lit when the input or output is ON.)
DIN track mounting hooks
DeviceNet Indicators
Power supply terminals
Communications connector
DIP switch
Pins 1 to 6: Node address setting
Pins 7 and 8: Baud rate setting
Pin 9: Reserved (Always OFF.)
Pin 10: Hold/clear o tp ts for comm nications error
Word address
Indicates the word which the
sensor uses.
(Refer to page 312.)
(Refer to page 40.)
Pins 1 to 6: Node address setting
Pins 7 and 8: Baud rate setting
Pin 9: Reserved (Always OFF.)
Pin 10: Hold/clear outputs for communications error
V+
V–
CAN L
CAN H
DRAIN
V
G
V
G
IN
OUT
Internal
circuitry
Non-isolated
power supply
Isolated
power
supply
Terminals for
one sensor
SOURCE
24 V DC +
SOURCE
24 V DC –
To Next Page
Loading...
