Omron DRT1 Series - Page 194

178
Connecting Communications Cables to Environment-resistive Slaves Section 5-2
System with Slaves using Round Shielded Connectors and Regular Square Connectors
Always use the communications cables listed in the following table to connect
Waterproof Terminals, Environment-resistive Transistor Terminals, and B7AC
Interface Units.
The blank spaces (@@) in the model numbers indicate the cable length in 0.1-
m units. For example, add “C5” for a cable 0.5 m long.
Note Standard thin DeviceNet cable is used for these cables, so the cables cannot
be used in an environment that is subject to spattering unless steps are taken
to protect the cables.
Model Description
DCA1-5CN@@W1 Cable with round shielded connec-
tors on both ends
DCA1-5CN@@F1 Cable with round shielded connec-
tor (female socket) on one end
DCA1-5CN@@H1 Cable with round shielded connec-
tor (male plug) on one end
DCN2-1 Shielded T-branch Connector (for
1 branch line)
DeviceNet Master Unit
T-branch Tap
T-branch Tap
DCA1-5CN@@H1 Cable
with shielded connector
on one end
DCN2-1 shielded
T-branch connector
Power supply
Environment-resistive
Terminals or other Slaves
using shielded connectors
I/O Power Supply Cable
Slaves using different
kinds of connectors
can be connected
through a T-branch
Ta p
Slave with normal
connector