Omron DRT1 Series - Page 202

186
Environment-resistive Terminals (IP66) Section 5-3
The following diagram shows the wiring of the DRT1-HD16C-1 Environment-
resistive Terminal (PNP).
Note 1. External power supply line 0V and input line G are connected internally, as
are external power supply line 24V and input line V. When input power is
supplied to external power supply connectors, power can be supplied to
sensors from input lines G and V provided that the total current does not
exceed 1.0 A. If the total current exceeds 1.0 A, the power must not be
supplied from the connector; it must be supplied externally instead.
2. Wire colors in parentheses are the previous JIS colors for photoelectric
and proximity sensors.
Dimensions The following diagram shows the dimensions for the DRT1-HD16C and
DRT1-HD16C-1 Environment-resistive Terminals. All dimensions are in mm.
+ −
2
13
4
VG
2
13
4
VG
2
13
4
VG
2
13
4
VG
2
13
4
VG
2
13
4
VG
2
13
4
VG
2
13
4
VG
1
24
3
2
31
4
5
DRAIN V−
V+
CAN LCAN H
+ −
CN3 CN4 CN5 CN6 CN7 CN8 CN9 CN10 CN2 CN1
2-wire sensor
(limit switch)
Input 0
Input 1
Blue (black)
Input 2
Input 3
Brown (white)
Input 4
Input 5
Input 6
Input 7
Blue (black) Black (white) Brown (red) Blue (black) Black (white) Brown (red)
PNP output 3-wire sensor
(photoelectric or proximity
sensor)
PNP output 3-wire sensor
(photoelectric or proximity
sensor)
Input 8
Input 9
Input 10
Input 11
Input 12
Input 13
Input 14
Input 15
(end surface)
Internal power
supply
I/O power
supply
215
51
196
45
57
8
205 0.3
+
--
28 0.3
+
--
205 0.3
+
--
28 0.3
+
--
6
0 1 2 3 4 5 6 7 8 91011 12 13 14 15 MS NS
Four, M5
When screw mounting
from the front
When screw mounting
from the rear
Four, 4.2 dia. or M4
Four, 5.4 dia.
Mounting screw
Nut
Mounting
screw
Mounting Holes