192
Environment-resistive Terminals (IP66) Section 5-3
The following diagram shows the wiring of the DRT1-WD16C-1 Environment-
resistive Terminal (PNP).
Note External power supply line 0V and output line G are connected internally, as
are external power supply line 24V and output line V. When output power is
supplied to external power supply connectors, power can be supplied to out-
put devices from output lines G and V provided that the total current does not
exceed 2.4 A. If the total current exceeds 2.4 A, the power must not be sup-
plied from the connector; it must be supplied externally instead.
Dimensions The following diagram shows the dimensions for the DRT1-WD16C and
DRT1-WD16C-1 Environment-resistive Terminals. All dimensions are in mm.
+
−
2
13
4
VG
2
13
4
VG
2
13
4
VG
2
13
4
VG
2
13
4
VG
2
13
4
VG
2
13
4
VG
2
13
4
VG
1
24
3
2
31
4
5
DRAIN V
−
V+
CAN LCAN H
+
−
CN3 CN4 CN5 CN6 CN7 CN8 CN9 CN10 CN2 CN1
Output 0
Output 1
Output 2
Output 3
Output 4
Output
5
Output 6
Output 7
Output 8
Output 9
Output 10
Output
11
Output 12
Output 13
Output
14
Output
15
(end surface)
I/O power
supply
Internal power
supply
Valve Solenoid Solenoid
215
51
196
45
57
8
205 0.3
+
--
28 0.3
+
--
205 0.3
+
--
28 0.3
+
--
6
8 9 10 11 12 13 14 15
MS NS
0 1 2 3 4 5 6 7
Four, M5
When screw mounting
from the front
When screw mounting
from the rear
Four, 4.2 dia. or M4
Four, 5.4 dia.
Mounting screw
Nut
Mounting
screw
Mounting Holes
To Next Page
Loading...
