Omron DRT1 Series - Page 215

199
Environment-resistive Terminals (IP66) Section 5-3
Sensors that are pre-wired with a connector can be connected directly.
Refer to the Catalog or manual for details on the device’s connections before
connecting any device.
Note 1. Refer to the OMRON Sensors Catalog (X42-E1-3) for more details on the
sensor connections and Round Waterproof Connectors.
2. One of the Y-joints listed in the following table will be needed when con-
necting sensors or limit switches to an Environment-resistive Terminal with
16 inputs (DRT1-HD16C(-1)) or 16 outputs (DRT1-WD16C(-1)).
Note An XS2G Connector Assembly (screw-in wire connection) cannot be con-
nected to a Y-joint Connector. A crimp-connector or soldered connector can
be connected to a a Y-joint Connector.
XS2R-D426-@11F Y-joint Connector with Cable
XS2R-D426-1 Y-joint Connector without Cable
XS2G-D4@@
XS2W-D42@-@81-A Cable
with shielded socket on one
end and plug on the other
XS2H-D421-@80-A Cable with
shielded plug on one end
Pre-wired Sensor
Sensor with attached connector
Pre-wired Sensor with connector
Connector Model number
Y-joint with plug/socket (with cable) XS2R-D426-@11F
Y-joint with plug/socket (no cable) XS2R-D426-1
XS2R-D426-@11F
Y-joint with cable
XS2R-D426-1 Y-joint
without cable
Terminal with 16
inputs or 16 outputs
4
CN2
3
2
1
4
CN1
3
2
1
1
2
3
4
4.6 dia.
CN1
CN2
18
45.5
L
8.5
13.6
35
15
6 dia.
44.7
Blue mark
Wiring diagram
1
CN2
2
3
4
1
CN1
2
3
4
1
CN0
2
3
4
4.5 dia.
7
CN2
CN1
CN0
18
24.5
12.5
27
58.3
(37)
15
Blue mark
Wiring diagram