Omron DRT1 Series - Page 85

69
Transistor Remote I/O Terminals with 3-tier I/O Terminal Blocks Section 4-4
The following diagram shows the wiring of the DRT1-ID16TA-1 Remote Input
Terminal.
Note 1. V1 is not connected internally to V2, and G1 is not connected internally to
G2. Connect them carefully.
2. Line colors have been changed accompanying changes in JIS standards
for photoelectric and proximity sensors. Previous colors are given in paren-
theses.
Dimensions The following diagram shows the dimensions for the DRT1-ID16TA and
DRT1-ID16TA-1 Remote Input Terminals. All dimensions are in mm.
Note The circuit section can be removed by loosening the circuit removal screws.
(Refer to Components of the DRT1-ID16TA and DRT1-ID16TA-1.)
7
V1
G1
1
V1
G1
0
V1
G1
V1
G1
−+
15
V2
G2
9
V2
G2
8
V2
G2
V2
G2
−+
Black (white)
Brown (red)
Blue (black) Blue (black)
Brown (white)
Black (white)
Brown (red)
Blue (black) Blue (black)
Brown (white)
3-wire sensor with
PNP output
(photoelectric or
proximity sensor)
2-wire sensor
(e.g., limit switch)
3-wire sensor with
PNP output
(photoelectric or
proximity sensor)
2-wire sensor
(e.g., limit switch)
Two, 4.2 dia. or M4
Mounting holes
170±0.2
40±0.2
58
(83)
180
50
(54)
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
IN
DRT1-ID16TA
REMOTE TERMINAL DC24V
NS
MS
DR0
ON
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
DR1 NCNC
Values in parentheses
are reference values.