Omron NX1P2 series Hardware User Manual

The appearance of the terminal block is the same as (a).
NC
NC
N
C
NC
NC
NC
NC
NC
08
NC09
06
07
04
05
02
03
00
01
C0
(0V)
NC NC
Symbol Terminal name Description Reference
C0(0V) Common terminal Connected to the 0-V side of the I/O
power supply
.
Output Specifications on page
3-17
00 to 09
Output terminals NPN (sinking) type output
NC NC Do not connect anything. ---
d.
NX1P2-9£24DT1
The appearance of the terminal block is the same as (a).
NC
NC
N
C
NC
NC
NC
NC
NC
08
NC09
06
07
04
05
02
03
00
010V0
NC
C0
(+V)
Symbol Terminal name Description Reference
C0(+V) Common terminal Connected to the 24-V side of the I/O
power supply
.
Output Specifications on page
3-17
0V0
0 V terminal Supplies 0 V for the internal circuits for
driving.
00 to 09 Output terminals PNP (sourcing) type output with the
load short-circuit protection function
NC NC Do not connect anything. ---
3 Configuration Units
3-16
NX-series NX1P2 CPU Unit Hardware User’s Manual (W578)

Omron NX1P2 series Specifications

General

Model	NX1P2 Series
Manufacturer	Omron
Type	Controller
CPU Units	1
Program Capacity	5 MB
Data Memory Capacity	128 KB
Ethernet Ports	1
Serial Ports	1
Built-in EtherNet/IP Port	Yes
Built-in EtherCAT Port	Yes
Built-in USB Port	Yes
SD Memory Card Slot	Yes
USB Port	1
Power Supply Voltage	24 VDC
Programming Language	Ladder, Structured Text, Function Block Diagram
Communication Protocols	EtherNet/IP, EtherCAT, Serial (RS-232C)