Omron SmartSlice GRT1 Series - Page 329

309
Explicit Messages Appendix A
Note (1) The Instance ID specifies the Slice I/O Unit’s unit number (1 to 64 decimal).
(2) Specifies output 0.
(3) Specifies output 1.
(4) Specifies output 2.
(5) Specifies output 3.
(6) Specified output 4 (Eight-output Units only).
(7) Specified output 5 (Eight-output Units only).
(8) Specified output 6 (Eight-output Units only).
(9) Specified output 7 (Eight-output Units only).
(10) Bit numbers correspond to output numbers, e.g., bit 00 corresponds to output 0.
Reset Out-
put Mainte-
nance
Counter
Reset Resets the total ON
time (unit: s) or
number of contact
operations (unit:
operations) for the
output (0 to 3, or 0
to 7 for an Eight-out-
put Unit) specified
by the Attribute ID.
05 hex 8E hex 01 to 40
hex
*1
77 hex
*2
7A hex
*3
7D hex
*4
80 hex
*5
A7 hex
*6
AA hex
*7
AD hex
*8
B0 hex
*9
--- ---
Read Moni-
tor Status of
Output
Mainte-
nance
Counter
Read Reads the monitor
status for total ON
time or number of
contact operations
for the outputs.
0E hex 8E hex 01 to 40
hex
*1
86 hex --- 4 bytes
Read informa-
tion for points 0
to 32.
0: In range
1: Out-of-range
(over the moni-
tor value)
The status is
read for out-
puts 0 to 32.
*10
Explicit
message
Read/
write
Function Command Response
Service
code
Class
ID
Instance
ID
Attribute
ID
Data size