vii
Notation in this Manual
This manual uses the following notation.
• “Loop Controller” is used as a generic term to refer to the Loop Controllers in
general.
•“LCB@@” is used to refer to specific Loop Controller functional elements.
For example, the Loop Controller function element in a CS1W-LCB05 Loop
Control Board is the LCB05, so “LCB05” is used to refer to the Loop Control-
ler functional element. The Loop Controller function element in a CJ1G-
CPU44P Loop-control CPU Unit is the LCB03, so “LCB03” is used to refer to
the Loop Controller functional element.
• Model numbers are used to refer to specific Loop Controller models.
In the CX-Process Tool Operation Manual for version 3.2 or lower, functional
element names (LCB@@) are given as “Loop Control Board.” In the CX-Pro-
cess Tool Operation Manual for version 4.0 or higher, simply “LCB@@” is
used.
To Next Page
Loading...
