Onkyo A-9000R User Manual

27
En
Combined with a preamplifier of your choice, the integrated amplifier can be used as a power amplifier (Main mode). When it is selected, the MAIN IN LED lights. See “Connecting Your Speakers”
for connection information (➔ page 15). This is an example of connection using the preamplifier P-3000R.
Using the Integrated Amplifier as a Power Amplifier
Important:
• Always turn the integrated amplifier off before connecting the MAIN IN jacks.
• Before setting the integrated amplifier to Main mode, make sure that no component such as a CD player is connected to the MAIN IN jacks, as a direct connection may cause a massive blast sound and damage the integrated
amplifier or your speakers.
• This mode can be used with the following limitations:
– The volume level can’t be adjusted.
–Only SPEAKERS and SETUP can be used.
–Only the MAIN IN and SPEAKERS terminals can be used.
– The Auto Standby function is not available (➔ page 38).
• To use this mode, you need to change the “ROUTE” setting (➔ page 39).
Preamplifier P-3000R
Integrated Amplifier A-9000R

Onkyo A-9000R Specifications

General

Output level	0.001 mV
Damping factor	130
Amplifier class	-
Frequency range	1 - 250000 Hz
Output impedance	300 Ω
Input sensitivity	150 mV
Audio output channels	- channels
Peak power per channel	140 W
Signal-to-Noise Ratio (SNR)	107 dB
Total Harmonic Distortion (THD)	0.05 %
Dynamic power per channel (2 Ohm)	310 W
Dynamic power per channel (3 Ohm)	230 W
Dynamic power per channel (4 Ohm)	180 W
Dynamic power per channel (8 Ohm)	100 W
AC (power) in	Yes
Audio (L/R) in	1
Speakers connectivity type	RCA
Purpose	Home
Product color	Silver
Cables included	AC
Connectivity technology	Wired
AC input voltage	230 V
AC input frequency	50 Hz
Power consumption (standby)	0.2 W
Power consumption (typical)	300 W
Package weight	22500 g

Weight and Dimensions

Width	435 mm
Height	175 mm
Weight	18500 g