36
En
Advanced Op erations
Custom Setup
You can perform custom settings using SETUP on the
remote controller or the integrated amplifier. The SETUP
menu allows you to set the following items: NAME,
SHOW, HPLVL, ASb, ROUTE, and RESET.
Note
• When “ROUTE” is set to “MAIN”, the “NAME”, “SHOW”,
“HPLVL” and “ASb” settings are not available.
• When the “USB” or “PHONO” input is selected, “NAME”
setting is not available.
You can change the name of the currently selected input.
Choose a name from the following: CD, SACD, MD,
TAPE , TUNER, TV, GAME, PC, DOCK
■ Operating with the remote controller ■ Operating on the integrated amplifier
Tip
• By default, input names are set according to the terminal names.
Note
• If you assign a name that is already used on another input, the
name of that other input will be restored to its default.
•When the “USB” or “PHONO” input is selected, “NAME”
setting is not available.
• The integrated amplifier will end the setup if there is no
operation for 8 seconds.
Changing Input Names
RST-NO RST-YES
NAME
SHOW
HPLVL
ASb
ROUTE
RESET
CD SACD MD TAPE TUNER
L1 L2 L3 CX1 CX2 OPT
HP -12 HP 0 HP +12
ASb-ON ASb-OFF
DOCK PC GAME TV
PNO USB AES
MAIN SPLIT
NORMAL PRE
1
Press SETUP.
2
Press !/" repeatedly to select “NAME”.
3
Press ENTER.
The name currently assigned to the input flashes.
4
Press #/$ repeatedly to select the name you want
to assign.
The selected name flashes.
5
Press ENTER.
The selected name flashes rapidly for a few times as
the setting is confirmed.
6
Press RETURN repeatedly to exit the setup.
SETUP
!/"/#/$
ENTER
RETURN
1
Press SETUP repeatedly to select “NAME”.
2
Use the INPUT selector to select the name you want
to assign.
First, the currently assigned name flashes on the
information display. Then, the assignable names are
displayed flashing.
3
Press and hold down SETUP.
The selected name flashes rapidly for a few times as
the setting is confirmed.
4
Press SETUP repeatedly to exit the setup.
SETUP
INPUT selector
To Next Page
Loading...
Need help?
General
Weight and Dimensions
