EasyManuals Logo

Onkyo A-9000R User Manual

Onkyo A-9000R
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #31 background imageLoading...
Page #31 background image
31
En
You can adjust the bass, treble and left/right output
balance respectively.
Operating with the remote controller
Operating on the integrated amplifier
Tip
By default, bass and treble are set to 0, and balance is set to the
center position (no visible bars).
Note
The integrated amplifier will end the adjustment if there is no
operation for 5 seconds.
While the Direct function is enabled, the tone controls are
disabled and pressing the buttons will display the message
DIRECT”.
When headphones are connected, the balance can’t be adjusted
and pressing the buttons will display the message “PHONES”.
Adjusting the Bass, Treble and Balance
1
Press TONE/BAL repeatedly.
` BASS:
` TRBL (Treble):
You can adjust the bass and treble levels from -6
to +6.
` L, R (Balance):
The left and right output balance can be adjusted.
The more the bars move to the right, the higher
the volume will be on the right output.
Conversely, the more the bars move to the left,
the higher the volume will be on the left output.
When no bar appears on the display, the volume
is evenly distributed.
2
Press #/$ repeatedly.
The adjustment is automatically confirmed.
To exit the adjustment, press RETURN.
TONE/BAL
RETURN
#/$
1
Press BASS -/+, TREBLE -/+, or BALANCE L/R
repeatedly.
The adjustment is automatically confirmed.
BASS -/+ TREBLE -/+ BALANCE L/R
You can temporarily mute the output of the integrated
amplifier.
Note
While the integrated amplifier is muted:
Adjusting the volume or setting the integrated amplifier to
Standby will unmute the integrated amplifier.
Pressing INPUT!/" on the remote controller or turning the
INPUT selector on the integrated amplifier will display the
current input for 3 seconds.
•If MUTING is pressed while a setting is being performed, the
setup will be terminated.
Even if the power is turned off or the power cord is unplugged,
the muting function will be maintained on to the next session.
Muting the Sound
1
Press MUTING.
The message “MUTING” flashes on the information
display.
To unmute the integrated amplifier, press MUTING
again.
MUTING

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Onkyo A-9000R and is the answer not in the manual?

Onkyo A-9000R Specifications

General IconGeneral
Output level0.001 mV
Damping factor130
Amplifier class-
Frequency range1 - 250000 Hz
Output impedance300 Ω
Input sensitivity150 mV
Audio output channels- channels
Peak power per channel140 W
Signal-to-Noise Ratio (SNR)107 dB
Total Harmonic Distortion (THD)0.05 %
Dynamic power per channel (2 Ohm)310 W
Dynamic power per channel (3 Ohm)230 W
Dynamic power per channel (4 Ohm)180 W
Dynamic power per channel (8 Ohm)100 W
AC (power) inYes
Audio (L/R) in1
Speakers connectivity typeRCA
PurposeHome
Product colorSilver
Cables includedAC
Connectivity technologyWired
AC input voltage230 V
AC input frequency50 Hz
Power consumption (standby)0.2 W
Power consumption (typical)300 W
Package weight22500 g
Weight and Dimensions IconWeight and Dimensions
Width435 mm
Height175 mm
Weight18500 g

Related product manuals