EasyManuals Logo

Onkyo A-9000R User Manual

Onkyo A-9000R
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #18 background imageLoading...
Page #18 background image
18
En
Tip
To reduce noise, do not tie signal cables together with the power
cable. Wire them so that they are away from each other.
Depending on the country, the integrated amplifier may be
polarity-sensitive. In this case, plug the power cord in a way that
provides the best sound quality.
Note
Never disconnect the power cord from the integrated
amplifier while the other end is still plugged into a wall
outlet. Doing so may cause an electric shock. Always disconnect
the power cord from the wall outlet first, and then the integrated
amplifier.
Turning on the integrated amplifier may cause a momentary
power surge that might interfere with other electrical equipment
on the same circuit. If this is a problem, plug the integrated
amplifier into a different branch circuit.
Do not use a power cord other than the one supplied with the
integrated amplifier. The supplied power cord is designed
exclusively for use with the integrated amplifier and should not
be used with any other equipment.
Connecting the Power Cord
Integrated Amplifier A-9000R
Supplied power cord
To an AC wall outlet
(Plug type varies from country to country.)
1
Connect all of your speakers and components.
2
Connect the supplied power cord to the integrated
amplifier’s AC INLET.
3
Plug the power cord into an AC wall outlet.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Onkyo A-9000R and is the answer not in the manual?

Onkyo A-9000R Specifications

General IconGeneral
Output level0.001 mV
Damping factor130
Amplifier class-
Frequency range1 - 250000 Hz
Output impedance300 Ω
Input sensitivity150 mV
Audio output channels- channels
Peak power per channel140 W
Signal-to-Noise Ratio (SNR)107 dB
Total Harmonic Distortion (THD)0.05 %
Dynamic power per channel (2 Ohm)310 W
Dynamic power per channel (3 Ohm)230 W
Dynamic power per channel (4 Ohm)180 W
Dynamic power per channel (8 Ohm)100 W
AC (power) inYes
Audio (L/R) in1
Speakers connectivity typeRCA
PurposeHome
Product colorSilver
Cables includedAC
Connectivity technologyWired
AC input voltage230 V
AC input frequency50 Hz
Power consumption (standby)0.2 W
Power consumption (typical)300 W
Package weight22500 g
Weight and Dimensions IconWeight and Dimensions
Width435 mm
Height175 mm
Weight18500 g

Related product manuals