EasyManuals Logo

Onkyo A-9000R User Manual

Onkyo A-9000R
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #30 background imageLoading...
Page #30 background image
30
En
You can adjust the brightness of the integrated amplifier’s
information display.
Note
While the information display is turned off, pressing the buttons
used for settings and adjustments on the remote controller or
integrated amplifier will briefly activate the display in Dim
mode.
Adjusting the Display Brightness
Display Off LED
DIMMER
1
Press DIMMER repeatedly.
NormalDim Off
Normal
Dim
Off
The Display Off LED lights.
By bypassing the tone control circuit, the Direct function
uses the shortest path for enhanced sound quality.
Although this function generally turns the display off, the
integrated amplifier makes use of a display that doesn’t
affect the sound quality. It is therefore possible to turn the
display on while the Direct function is enabled. Also,
since the left/right balance setting uses a system that
doesn’t affect the sound quality, the balance can be
adjusted even if the Direct function is enabled.
Tip
To turn the information display on while the Direct function is
enabled, press DIMMER on the remote controller.
Using the Direct Function
1
Set the DIRECT switch to the ON position.
The information display goes off and the DIRECT
LED lights.
DIRECT LEDDIRECT switch

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Onkyo A-9000R and is the answer not in the manual?

Onkyo A-9000R Specifications

General IconGeneral
Output level0.001 mV
Damping factor130
Amplifier class-
Frequency range1 - 250000 Hz
Output impedance300 Ω
Input sensitivity150 mV
Audio output channels- channels
Peak power per channel140 W
Signal-to-Noise Ratio (SNR)107 dB
Total Harmonic Distortion (THD)0.05 %
Dynamic power per channel (2 Ohm)310 W
Dynamic power per channel (3 Ohm)230 W
Dynamic power per channel (4 Ohm)180 W
Dynamic power per channel (8 Ohm)100 W
AC (power) inYes
Audio (L/R) in1
Speakers connectivity typeRCA
PurposeHome
Product colorSilver
Cables includedAC
Connectivity technologyWired
AC input voltage230 V
AC input frequency50 Hz
Power consumption (standby)0.2 W
Power consumption (typical)300 W
Package weight22500 g
Weight and Dimensions IconWeight and Dimensions
Width435 mm
Height175 mm
Weight18500 g

Related product manuals