Onkyo A-9000R

4
En
Features
• 140 W/Ch (4 ohm, 20 Hz - 20 kHz, 0.05%,
2 Channels Driven, IEC)
• A WRAT (Advanced Wide Range Amplifier
Technology)
• DIDRC (Dynamic Intermodulation Distortion
Reduction Circuitry)
• Quad Push-Pull Amplification Design with
Three-Stage Inverted Darlington Circuitry
• Symmetrical Layout of Power Stage
• Four Large 18,000 µF Capacitors
• Anti-Vibration Aluminum Panels for Front
and Sides
• Side-mounted Circuit Board Construction to
Reduce Vibration
• Separate Digital/Analog Circuitry
• Low-noise Static Display
• PLL Ultra-Low Jitter Technology
• Separate Wolfson 192 kHz/24-Bit DACs
(WM8742) for L/R Channels
• Direct Mode
• Tone Control (Bass/Treble)
• Balance Control
• Independent Headphone Amplifier
• Discrete Phono Equalizer
• Phono Input (MM/MC)
• De-emphasis Function
*1
• USB Digital Input for 192 kHz/24-Bit HD
Audio from PC
*2
• AES/EBU Balanced Digital Input with XLR
Connector
• 4 Digital Inputs (1 AES/EBU, 2 Coaxial and 1
Optical)
• Gold-Plated, Machined Solid Brass RCA
Inputs
• Gold-Plated Large Speaker Posts
• Display Dimmer (Normal/Dim/Off)
*1
This function only applies to the following
sampling rates: 32 kHz, 44.1 kHz, 48 kHz. Other
rates are not supported.
*2
Playback of PC audio requires dedicated software
that can be downloaded from the Onkyo web site.
Audio signals of up to 32 bit can be input.
However, the resulting output will be equivalent
to a quality of 24 bit.