32
En
You can display information such as the current input or
the value of settings.
Note
• Input fs (sampling rate) is displayed only when a digital input
(COAX1, COAX2, OPT, AES-EBU, USB) is selected.
• Depending on the source, the value on the information display
may differ from the actual sampling rate’s.
• When the Direct function is enabled, “BASS” and “TRBL” are
not displayed.
• When a signal treated for treble emphasis (pre-emphasis) is
detected, the integrated amplifier is designed to restore the
original signal characteristics via the “de-emphasis” process.
The message “EMPHAS” only appears when a signal processed
with pre-emphasis is detected.
• When “ROUTE” is set to “MAIN”, DISPLAY can’t be used
(➔ page 39).
Tip
• When a variation of sampling rate is detected, the value is
automatically displayed.
Changing the Display Information
1
Press DISPLAY repeatedly.
DISPLAY
Current Input
Current Volume
BASS Level
TRBL (Treble) Level
Input fs (sampling rate)
Pre-emphasis Signal Detection
To exit the adjustment, press RETURN.
Setting of ROUTE
Tip
• If there’s a volume difference between your speakers and your
headphones, you can adjust the offset level (➔ page 37).
Note
• Always turn down the volume before connecting your
headphones.
• When headphones are connected, the balance adjustment and
SPEAKERS are disabled. Pressing the buttons will display the
message “PHONES”.
Using Headphones
1
Connect a pair of stereo headphones with a
standard plug (6.3 mm) to the PHONES jack.
When connecting the headphones, the message
“PHONES” appears on the information display and
the A/B LEDs go off.
You can adjust the volume and mute the sound, by
using VOLUME q/w.
While headphones are connected, no sound is output
from the speakers and PRE OUT jacks.
PHONES jack
To Next Page
Loading...
Need help?
General
Weight and Dimensions
