Onkyo A-9000R User Manual

38
En
■ Operating on the integrated amplifier
Tip
• The default level is 0.
Note
• The integrated amplifier will end the setup if there is no
operation for 8 seconds.
1
Press SETUP repeatedly to select “HPLVL”.
2
Use the INPUT selector to adjust the offset level.
First, the current level flashes on the information
display. Then, the value is adjusted.
The setting is automatically confirmed.
3
Press SETUP repeatedly to exit the setup.
SETUP
INPUT selector
When the Auto Standby (ASb) function is activated, the
integrated amplifier will automatically enter Standby
mode if there is no operation for 30 minutes with no audio
signal input.
■ Operating with the remote controller
Once the Auto Standby (ASb) function has been activated,
the integrated amplifier will not automatically turn on
even if it receives a signal. To turn on the integrated
amplifier, press 8ON/STANDBY on the integrated
amplifier or 8 on the remote controller manually.
■ Operating on the integrated amplifier
Tip
• The default setting is ON.
Note
• When the Auto Standby (ASb) function is activated, Onkyo
components connected via u are automatically turned off
(➔ page 22).
• Before entering Standby mode with the Auto Standby (ASb)
function, the message “ASb” flashes for 30 seconds on the
information display.
• The integrated amplifier will end the setup if there is no
operation for 8 seconds.
Setting the Auto Standby Function
1
Press SETUP.
2
Press !/" repeatedly to select “ASb”.
3
Press ENTER.
The current setting is displayed.
4
Press #/$ to switch between “ASb-ON” and
“ASb-OFF”.
` ASb-ON:
Enables Auto Standby.
` ASb-OFF:
Disables Auto Standby.
The setting is automatically confirmed.
5
Press RETURN repeatedly to exit the setup.
SETUP
!/"/#/$
ENTER
RETURN
1
Press SETUP repeatedly to select “ASb”.
2
Use the INPUT selector to switch between
“ASb-ON” and “ASb-OFF”.
First, the current setting flashes on the information
display. Then, the setting is switched ON/OFF.
The setting is automatically confirmed.
3
Press SETUP repeatedly to exit the setup.
SETUP
INPUT selector

Onkyo A-9000R Specifications

General

Output level	0.001 mV
Damping factor	130
Amplifier class	-
Frequency range	1 - 250000 Hz
Output impedance	300 Ω
Input sensitivity	150 mV
Audio output channels	- channels
Peak power per channel	140 W
Signal-to-Noise Ratio (SNR)	107 dB
Total Harmonic Distortion (THD)	0.05 %
Dynamic power per channel (2 Ohm)	310 W
Dynamic power per channel (3 Ohm)	230 W
Dynamic power per channel (4 Ohm)	180 W
Dynamic power per channel (8 Ohm)	100 W
AC (power) in	Yes
Audio (L/R) in	1
Speakers connectivity type	RCA
Purpose	Home
Product color	Silver
Cables included	AC
Connectivity technology	Wired
AC input voltage	230 V
AC input frequency	50 Hz
Power consumption (standby)	0.2 W
Power consumption (typical)	300 W
Package weight	22500 g

Weight and Dimensions

Width	435 mm
Height	175 mm
Weight	18500 g