OPTIMUM
MASCHINEN - GERMANY
Maintenance
© 2008
GB
Page 374 February 2008 version 1.3.1 S210G; S275G; S210G Vario; S275G Vario Metal belt saw
Start of shift
after each mainte-
nance or repair
operation
Metal belt saw
“Safety check“ on page 11
every week
Drive shaft
Bearing
• Lubricate
every month
Helical gear
Visual inspection
Check the oil level through the inspection window of
the helical gear.
INFORMATION
During the first few days in service, the heli-
cal gear may become quite hot. If the tempera-
ture does not exceed 70ºC, no further
measures need be taken.
This running-in process can improve consid-
erably if a little Molykote G gear paste is
added to the oil in the helical gear before the
machine is first used. This reduces wear in
the flanks of the teeth and increases the use-
ful service life of the gear.
as required
Work-holder vice
Spindle
Lubricate the spindle of the work-holder vice
Intervals /
When?
Where? What? How?
To Next Page
Loading...
