optris CompactPlus Connect - Page 103

CSvision 103-
Hold Low-High
input (digital)
The last value will be held if there is a signal with a rising edge on the I/O
pin.
Hold High-Low
input (digital)
The last value will be held if there is a signal with a falling edge on the I/O
pin
Hold Reset Low
input (digital)
Reset of a hold function on a Low level at the I/O pin
Hold Reset High
input (digital)
Reset of a hold function on a High level at the I/O pin
Slope external
input (analog)
External adjustment of the slope value using an analog voltage (0-10V)
Emissivity external
input (analog)
External adjustment of the emissivity value using an analog voltage (0-10V)
Uncommitted Value
input (analog)
Display of a freely scalable value
Laser on Low
input (digital)
Switch on laser (Low signal)
Laser on High
input (digital)
Switch on laser (High signal)
Low-/High-level: via software