Oracle Database Appliance - Page 110

Remove Disk Midplane Module
110 Oracle Database Appliance Service Manual • February 2016
a.
Power off the system.
See “Shutting Down a Server Node and Powering Off the System” on page 31.
b.
Disconnect the power cords from the system.
c.
If the system is installed in a rack, remove it.
See the Oracle Database Appliance Owner's Guide for information on racking the system
chassis.
d.
Remove both power supplies from the system.
See “Remove a Power Supply” on page 58.
e.
Attach an antistatic wrist strap.
See “Performing Electrostatic Discharge and Antistatic Prevention Measures” on page 34.
2.
Remove all of the front storage drives.
See “Remove a Storage Drive” on page 50.
3.
Remove both server nodes from the system.
See “Removing Server Nodes From the System Chassis” on page 34.
4.
Remove the middle section of the system top cover.
See “Removing the Middle Section of the System Top Cover” on page 36.
5.
Loosen the two captive Phillips screws that secure the side-wall cover to the
chassis and remove the cover.