Remove PCIe Card From PCIe Riser
76 Oracle Database Appliance Service Manual • February 2016
■
“Remove Primary HBA PCIe Card From Motherboard” on page 80
■
“Install Primary HBA PCIe Card in Motherboard” on page 81
PCIe Card Configuration
The Oracle Database Appliance (original version) PCIe expansion system includes one
standalone low-profile slot on the motherboard and a PCIe riser with three slots. These are
provisioned as follows:
■
Motherboard slot – A low-profile, dual-port SAS-2 HBA used internally
■
PCIe slot 2 – Dual-port SAS-2 HBA used internally
■
PCIe slot 1 – Quad-port 1-Gb Ethernet NIC
■
PCIe slot 0 – Dual-port 10-Gb Ethernet NIC
Caution - If you replace a PCIe card, ensure the replacement is identical to the card you are
replacing.
Remove PCIe Card From PCIe Riser
1.
Prepare the server node for service.
a.
Attach an antistatic wrist strap.
See “Performing Electrostatic Discharge and Antistatic Prevention Measures” on page 34.
b.
Remove the server node from the system.
Power is removed from the server node when you remove it from the system. See
“Removing Server Nodes From the System Chassis” on page 34.
c.
Remove the server node top cover.
See “Removing the Server Node Top Cover” on page 35.
2.
Locate the PCIe card in the PCIe riser that you want to remove.
See the "Oracle Database Appliance (Original Version) Back Panel" section of the Oracle
Database Owner's Guide for the location of the PCIe slots.
3.
If necessary, make a note of where the PCIe cards are installed.
4.
Disconnect all data cables from the PCIe card.
To Next Page
Loading...
Need help?
General
