Installing Oracle Secure Backup on Linux or UNIX with installob
Installing Oracle Secure Backup on Linux or UNIX 2-11
If you choose to create attach points later, or if you add a tape device to a
media server in the future, then see "Creating Attach Points with makedev" on
page 2-12 for two alternative methods of completing this task.
■ Enter yes to configure tape devices now.
To create attach points, the installob script asks if tape libraries are
connected to this host, and if so, what the SCSI parameters are for each tape
library. After you have entered the tape library SCSI parameters, the
installob script asks you to confirm your entries.
When you have entered information about tape libraries attached to this host,
the installob script asks the same questions about standalone tape drives.
Table 2–2 lists the information required by installob for each platform. For
the device type, enter a d for a tape drive or l (lowercase L) for a tape library.
Enter each parameter value in response to the prompts from the installob
script. You can press Enter to accept a default value, but the default SCSI
parameters offered by the script might not be correct.
When you have entered the SCSI parameters for all tape libraries and tape
drives attached to this host, the installob script begins device driver
configuration and device special file creation.
Record the name of the device special file created for each tape device. The
filename is needed when you configure the attachment for the tape device, as
part of configuring the Oracle Secure Backup domain. The filename should be
/dev/obtn for tape drives, and /dev/obln for tape libraries, where n is the
Oracle Secure Backup LUN you entered for the tape device.
If you enter the wrong parameters, then device special file creation fails. To
resolve the resulting errors, run installob again, entering the correct values,
or use the makedev script described in "Creating Attach Points with
makedev" on page 2-12.
When the installob script has created attach points for all tape devices
attached to this host, it reminds you that you must configure these tape
devices through the Oracle Secure Backup Web interface or the command line
using the mkdev command in obtool.
Table 2–2 Information Required by installob
Platform Linux HP-UX Solaris AIX
Oracle Secure Backup LUN
1
1
Do not confuse the Oracle Secure Backup logical unit number with the SCSI LUN.
xxxx
Device type x x x x
Host bus adapter x x
SCSI bus address
2
2
In Linux, SCSI bus addresses are referred to as channels.
xx
SCSI bus name-instance x x x x
Target ID x x x x
SCSI LUN x x x x
To Next Page
Loading...
Need help?
General