Configure RAID in UEFI Boot Mode
Note - Unlike in Legacy Boot Mode, in UEFI Boot Mode, you do not need to make the drive
bootable. In UEFI boot mode, the operating system installation procedure makes the drive
bootable.
1.
Configure the server for a one-time boot to BIOS.
a.
Access the Oracle ILOM web interface.
b.
Navigate to Host Management → Host Control.
c.
Select BIOS from the drop-down list, and then select Save.
The server is configured to boot to BIOS on the next boot.
2.
From the Summary window, select Remote Console → Launch and answer the
dialogs.
The remote console screen appears.
3.
Power on or reset the server.
For example, to reset the server:
■
From the local server, press the Power button (approximately 1 second) on the front panel
of the server to power off the server, and then press the Power button again to power on the
server.
■
From the Oracle ILOM web interface, select Host Management → Power Control, and
then select Power On from the Select Action list box. Click Save, and then click OK.
■
From the Oracle ILOM CLI, type: reset /System
4.
When prompted in the BIOS screen, press the F2 function key (Ctrl+E from a
serial connection) to launch the BIOS Setup Utility.
The BIOS Setup Utility appears.
Note - The steps and screens in this procedure are examples. What you actually see might differ
depending on your system's equipment and configuration.
Configuring Storage Drives for Operating System Installation 105
To Next Page
Loading...
Need help?
General